Trouble shooting the bowman switch
|
Trouble shooting
Now remove the tail screw from the light
and plug the flat jack into the hole where
the tail screw was. After pluging the flat
jack into the back of the light tighten the
set screw then touch the pointed jack
against the brass houseing, the light
should come on while touching the
houseing.
2.Insert flat jack into the back of the
light
1. make sure light works
Turn the tail screw into the back of the
light
(If light comes on proceed to step two)
3.Set the switch to the spot on the
cable gaurd where your cable slide
comes to a stop,now slide the switch
1/16 of an inch forward and snug set
screws on top and bottom.Plug your
pointed jack into the switch and your
automatic system is ready to use.
(After you are sure you have a good ground,and your light is lite while
touching the brass houseing your ready for the next step.)
